Components:
UHT Plants usually includes the following components:
-Closed balance tank including level transmitter and CIP device
-Centrifugal feed pump
-Electromagnetic flow transmitter
-Centrifugal water pump
-FSN Tubular Heat Exchanger including heating, regenerations and cooling sections.
-Holding tubes (Mounted as a sub unit on frame)
-Pressurized hot water unit including Brazed plate heat
exchanger, pump, steam control valve, steam trap, expansion chamber, shut off valves, air vent, safety valve, water Electromagnetic flow transmitter, expansion chamber, etc.
-Stainless steel control panel including PLC, HMI, power supply,
solenoid valves, motor starters etc.
-Automatic diversion valve
-Set of change over valves
-Set of shut off valves for water balance tank, ice water etc.
-Set of instruments such as temperature and pressure transmitters.
-Set of pipes and fittings
-Constant pressure valve
-All of the UHT plants are tested in our factory before delivery
-The UHT Panel/Programme ensures the following steps realized to ensure sterilization is realized properly:
-Pre sterilization
-Production
-Aseptic intermediate cleaning
-CIP
Before production starts, it is necessary to sterilize the aseptic area by circulating pressurized hot water in the system In the tubular version, the aseptic part is equipped with an internal sterilization loop to minimize energy consumption and start up time. After sterilization, the unit is cooled to product temperature. Finally, the sterile water is circulated through the production unit.